30 April 2016

Moar Mold

Using Lavender Linda Lovelace's lower, we attacked the "why is the take-down so fucking tight?"

We sanded the top of the lower to make it all even, it didn't leave the mold flat.

Then we removed a lot more material in the radius from the top of the lower to the front of the receiver extension boss (see pointer).


Now the take down pin can be pushed in with finger pressure and pushed out if you have a tool to push on the recessed end, but you no longer need to tap it out with a hammer.
at

3 comments:

  1. Old NFO30 April, 2016 22:49

    Nice catch. Do you think this will prevent the problem from the previous post?

    ReplyDelete
    Replies
    1. Angus McThag01 May, 2016 01:46

      Fingers crossed!

      Marv's going to pour a replacement for Blueberry real soon now and we're going to pay special attention to making sure the upper and lower fit together.

      Delete
  2. Old NFO01 May, 2016 15:49

    Thanks! I'll be interested to see how it turns out.

    ReplyDelete

You are a guest here when you comment. This is my soapbox, not yours. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.

If you're trying to comment anonymously: You can't. Log into your Google account.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.