10 July 2013

Kaylee Restored

The CORE-15 barrel nut went on in a textbook manner.

It stopped at the same halfway to a slot place but took much less torque to get it to line up.  I suspect the J&T nut might have bottomed out a bit.

Dialing the BUIS to line up with the Aimpoint gives a far more centered position for the windage on the rear sight.

Happy day!
at

2 comments:

  1. JD Rush11 July, 2013 00:02

    Stag has carbine gas 16" 6.8 SPC barrels in stock.
    http://www.stagarms.com/16-6-8-spc-m4-barrel/
    I recall you looking for one to make into a shorter barrel.

    ReplyDelete
  2. Angus McThag11 July, 2013 08:44

    I almost said, "but it has 1/2-36 muzzle threads and I prefer 5/8-24"... Then I realized that if I cut it down to 11.5" that I can put just about any thread I want there.

    Probably wont be getting it soon, but it's nice to see where I can find one. It just sucks that nobody makes what I want out of the box. Shortening the barrel makes it cost more.

    ReplyDelete

You are a guest here when you comment. This is my soapbox, not yours. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.

If you're trying to comment anonymously: You can't. Log into your Google account.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.