Posts
Today the parts arrived and I swapped the upper receivers between them.
The 20" is now a clone of a Canadian C7. The C7 is basically an M16A2 with the M16A1 rear sight and fire control, full auto instead of three round burst.
There was a little drama when I sent the front take-down detent sailing across the room. I had to run down to Kastle Keep Firearms in Clearwater to get a whole new lower parts kit just for one little detent.
As always I used Del-Ton for the kits and Anvil Arms for the lowers.
The XM177E3 carbine is now a flat-top and sports a Knight's 600m back-up iron sight and an EoTech 552.A65/1 reflex sight.
Here's the view through the EoTech
No comments:
Post a Comment
You are a guest here when you comment. This is my soapbox, not yours. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.
Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.
If you're trying to comment anonymously: You can't. Log into your Google account.
If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.