07 December 2017

I Can Ruin Your Stock Too!


Something goes catastrophically wrong every time I try to make the 75˚ cuts.

All I am doing is trying to follow the existing line and making the groove a little wider.

I don't know what I am doing wrong, I can't tell how I did the first lines perfect and can't make any more.

I think this experiment is done.

Good news, my amateur gouges sanded out pretty well.


2 comments:

  1. This is counter intuitive, but should you have started with the 75 degree for a light groove then "deepened" with the 60 degree? I know nothing of this art but have done a bit of single tool carving and trying to widen a deep groove seems to cause burring as the wood is a tad weaker where the first tool made the gouge near the surface of the work piece.

    ReplyDelete
    Replies
    1. The spacer cutter is two parallel 60˚ cutters.

      I think I am starting those too deep and it's obliterating the crossing groove the 75˚ cutter needs to ride in.

      The only problem is doing the initial lines is a non-trivial amount of effort to get to the point where you can see if this theory is good.

      Delete

You are a guest here when you comment. This is my soapbox, not yours. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.

If you're trying to comment anonymously: You can't. Log into your Google account.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.