14 October 2015

Mixed Success

The parts for the MAB Modele C did not fit.  Numrich sent the wrong firing pin altogether and the tumbler assy. was a 0.113" hole going on a 0.118" shaft.

While we could hog out that hole, Willard is going to attempt to RMA the parts first.

The mainspring housing swap on the PT1911 went much better!  The part dropped in like it was supposed, but the frame needed to be beveled a little on the outside of the tail just a little to eliminate some razor sharp snag points.

We discovered that a Colt .22 conversion will not fit on a Taurus and confirmed (with my .38 Super) that such conversions will not work with Series 80 lockwork.

No comments:

Post a Comment

Try to remember you are a guest here when you comment. Inappropriate comments will be deleted without mention. Amnesty period is expired.