06 July 2016


The lower we ruined by over-drilling the rear pocket pilot hole might be salvageable.

There's enough thread left to hold a pistol grip, but no sure way to get the screw into the hole because it wants to skip out into the mistake.

But a stud threaded from the other end once we have the milling done should work, with a nut to secure the grip.

Stay tuned.

1 comment:

  1. The "bubba" way to fix it would be to fill the overdrilled area with something, typically an epoxy like JB Weld. Any excess can be trimmed away and the screw hole could either be studded like you are suggesting or the epoxy could be drilled and then threaded. Anyway, may fortune be with you in your salvage operation.


You are a guest here when you comment. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post.

If you're trying to comment anonymously: Sign your work.

Anonymous comments must pass a higher bar than others.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.