05 September 2019

Out With The Old


In with the new!


There's quite a bit of play in the old throw-out bearing.  I guess it was time to replace it.

Of note, there's two reliefs cut into the side of the bell of the torque tube.  One lines up perfectly with the bleeder.  The other...  Nope, nothing.

This got a moment of panic and took it off and compared it to the original part, the lines are in the same place.  All is well, I guess.

No comments:

Post a Comment

You are a guest here when you comment. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.

If you're trying to comment anonymously: Sign your work.

Anonymous comments must pass a higher bar than others. Repeat offenders must pass an even higher bar.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.