05 September 2019

That Is Not Right

I put the little clippy things back in the trans cooler lines.

They're the same little clippy things that were the bane of my existence on the radiator removal.

I know them now and have their measure.

Installed the remote bleeder to the hydraulic throw-out bearing.

I looked up the torque specs for the bolts that hold it to the torque tube...

106 ft-lb!

For those tiny things?

Nope, misread that.  INCH pounds.

Just barely over 8 ft-lb. or as we say in The Cavalry, "snug."  Marv refers to this as "just barely finger tight."

No comments:

Post a Comment

You are a guest here when you comment. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.

If you're trying to comment anonymously: Sign your work.

Anonymous comments must pass a higher bar than others. Repeat offenders must pass an even higher bar.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.