10 September 2019

Coming Soon

Notice:    Your vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines:
• Keep your speed at 55 mph (88 km/h) or less for the first 500 miles (805 km).
• Do not drive at any one constant speed, fast or slow, for the first 500 miles (805 km).  Do not make full-throttle starts. Avoid downshifting to brake or slow the vehicle.
• Avoid making hard stops for the first 200 miles (322 km) or so. During this time the new brake linings are not yet broken in. Hard stops with new linings can mean premature wear and earlier replacement. Follow this breaking-in guideline every time you get new brake linings.
Following break-in, engine speed and load can be gradually increased.

Been a while since this section of the owner's manual applied to me.

I think the section on brakes isn't relevant to a clutch swap though.

2 comments:

  1. There's a similar section in the manual for the 2010 VW golf TDI, but it said not to exceed 160kph/100mph.

    :D

    ReplyDelete
    Replies
    1. The Vette break in is for the engine and differential mostly.

      Most clutch places say to do lots of in town driving.

      Delete

You are a guest here when you comment. This is my soapbox, not yours. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.

If you're trying to comment anonymously: Sign your work. Try this link for an explanation: https://mcthag.blogspot.com/2023/04/lots-of-new-readers.html

Anonymous comments must pass a higher bar than others. Repeat offenders must pass an even higher bar.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.