12 October 2016

Conundrum

As the saying goes, "there's nothing more expensive than free [insert item here].

I have 100 rounds of Bitterroot Valley Ammunition Company's 300 gr Bear Load in .45 Colt that Willard gave me.

Their web page redirects endlessly.  Their phone is disconnected.

So I cannot simply ask, "is this load safe in an Anaconda?"

I have found conflicting information about velocity.  It's either 750 fps or 900 fps.

A couple of people stated that, in their opinions, that 900 fps is pushing .44 Magnum pressure, and I know that the Anaconda can take those.

I just want to make sure that it's not pushing Blackhawk or Contender only pressures.

One good thing about it being free is I can be OK with not shooting it.

2 comments:

  1. this is not going to help at all. Recently Yankee Marshal claimed that Rugers are no stronger than any other modern revolver....just the Ruger chambers a a bit longer, so the "Ruger only" loads were more about OAL than pressure levels.

    So if you want to bet your wheelie on that, if it chambers it should be safe. At least drop it in the wheel and see if it stays below the forcing cone.

    ReplyDelete
  2. I'd re-think that, if I were you. First, BVAC's quality control and reloading itself leave a lot to be desired. Second, anything advertised as a "bear load" is likely pushing the pressure limits and _could_ be loaded beyond what is safe in any firearm.

    Also, Oregon Trail (makers of Laser Cast and TrueShot bullets) says the reason for many "kabooms" is bullet set-back, _especially in the .40 S&W. If a light crimp allows the bullet to slip back into the case from the recoil of other rounds fired, it can cause a pressure spike high enough to disassemble the gun right there, right now in your hand. They posted this notice with the .40 cal bullets they sell, saying the .40 is especially sensitive to set-back, but I believe they stated it _can_ happen with other calibers, too.

    ReplyDelete

You are a guest here when you comment. This is my soapbox, not yours. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.

If you're trying to comment anonymously: Sign your work. Try this link for an explanation: https://mcthag.blogspot.com/2023/04/lots-of-new-readers.html

Anonymous comments must pass a higher bar than others. Repeat offenders must pass an even higher bar.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.