16 October 2018

Flush

My Marlin, Connie, had open holes in the top of her receiver where the scope mounts used to be.

I'd bought a set of plug screws, but they had slight caps on them and are proud of the top just wee little bit.


Just enough proud to keep the Lyman peep sight I'd added from dropping low enough to zero.

Today I got screws that have no cap, so they sit flush!


That should keep a small amount of dirt from accumulating on the top of my bolt!

No comments:

Post a Comment

You are a guest here when you comment. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.

If you're trying to comment anonymously: Sign your work.

Anonymous comments must pass a higher bar than others. Repeat offenders must pass an even higher bar.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.