20 February 2018

Baby Pics

It's a gun!

An NDS-2T receiver for a Tantal!

I didn't expect to have the center support already installed.  Sadly, I think that I have to remove that rivet to install the side-rail.

4 comments:

  1. If you are installing the original side rail, it should have a relief where the rivet is, as the originals have the same rivet

    ReplyDelete
    Replies
    1. It's AK-Builder's version of the side rail. Cheaper and comes with instructions, which are sorely lacking for the rare and expensive original.

      Both the original and the repop are held by the center support rivet at the front, rear/top rivet of the rear trunnion at the back and a new rivet at the center. All three get ground flush with the mount so you can screw on the rail.

      The Poles had to clear their funky selector switch, so their rail is unique to the Kbk wz.88.

      Delete
  2. Nice Photos. Good information. I like your post. Your content is very useful for all reader. Thank you for it.
    Modern Baby Names

    ReplyDelete

You are a guest here when you comment. This is my soapbox, not yours. Be polite. Inappropriate comments will be deleted without mention. Amnesty period is expired.

Do not go off on a tangent, stay with the topic of the post. If I can't tell what your point is in the first couple of sentences I'm flushing it.

If you're trying to comment anonymously: Sign your work. Try this link for an explanation: https://mcthag.blogspot.com/2023/04/lots-of-new-readers.html

Anonymous comments must pass a higher bar than others. Repeat offenders must pass an even higher bar.

If you can't comprehend this, don't comment; because I'm going to moderate and mock you for wasting your time.